Got Big Water

YouTube
YouTube Channel

Facebook
Facebook Page

Twitter
Twitter Page

Rural Water Supply Operations Seminar
Rural Water Supply Operations Seminar

Water Supply Officer Seminar
Water Supply Officer Seminar

Relay Pumping With Large Diameter Hose
Relay Pumping With Large Diameter Hose

Dry Fire Hydrants Seminar
Dry Fire Hydrants Seminar

Dry Fire Hydrant Designs and Installations
Dry Fire Hydrant Designs and Installations

Web Counters
Website Visitors
Since
June 22, 2009
3,960,915
Visitors Today
Nov 18, 2026
1,435



Official PayPal Seal

Drafting Tip #19 - Dual Suctions Regardless of Pump Size

Print this story (opens in a new tab)News RSS feed (opens in a new tab)Share on Facebook (opens in a new window)Share on X (opens in a new window)Add a comment

By President Mark Davis
December 19, 2019

We can never emphasize enough the importance of getting as many suction lines into the water source as possible when operating as a water supply piece. Granted, in most cases the size of the motor will dictate the final performance of the rig. But just about every pump configuration will see improved capacity performance when adding additional suction lines beyond what was used in the certification layout. A good example is shown in the photos here as Pea Ridge Engine 101 (1,000 gpm) uses dual, 6-inch suctions to support a 1,000 gpm tanker loading station. While a single suction line may have achieved the desired flow, getting the second suction in the water certainly guaranteed it. Another example of why pumpers in rural areas should carry more than 20-feet of suction hose. The photos were taken during our 2010 rural water supply seminar in Shelby County, Alabama.

Website Designed and Hosted By: Content Proudly Maintained By: Contact Info:
Firehouse Solutions
www.FirehouseSolutions.com
GBW Associates, LLC
3178 Cardinal Drive
Westminster, MD 21157

Emergency Dial 911
Phone: 443-398-6619
E-mail: thebigcamel@gotbigwater.com
Copyright © 2026 Firehouse Solutions (A Service of Technology Reflections, Inc.)