The "stuff" that is carried on a pumper's backstep says alot about the readiness of the rig and its capabilities. Engine 54-4 from the Eureka VFC in Stewartstown, PA is set-up to operate as a water supply unit. The 1992 Alleghany pumper is equipped with a Hale Q-Max 1,750 gpm pump and a carries a split bed of 4-inch LDH totaling 3,600 ft. A look at its backstep lets you know that it is ready to layout some hose and supply water! Of special note are the dual, Jaffrey Z-valves - which are in-line relay pumping valves that allow for hose to be layed and charged and then a pumper added "in-line" in order to improve pumping efficiency and water flow delivery.
The Jaffrey Z-valve was perhaps the most popular in-line pumping valve throughout the Northeast and the Mid-Atlantic areas. Today, TFT has acquired some of the Jaffrey product patents and offers the TFT Oasis valve as an in-line relay pumping valve.
Engine 54-4's 4WD capability and short wheel base make it quite capable as a water supply pumper - not to mention its 1,750 gpm pump!
The pumper is equipped with an assortment of appliances and adaptors to handle all types of water supply scenarios.
Dual, Jaffrey Z-valves are on this rig's backstep - ready to lay dual 4-inch supply lines in a forward or reverse layout.
Engine 54-4 is shown here as a draft source pumper during our 2-day Rural Pump Operator Course in 2012.
The Jaffrey Z-valve has been around a long time - and while it is no longer made - the concept lives on with other manufacturers.