Dry Fire Hydrant Repair & Maintenance #02 - Paint Before Glue Creates a Problem |
| By President Mark Davis | |
| August 18, 2016 | |
A couple of years ago we were contracted to repair a dry fire hydrant at a quarry in New Windsor, Maryland. The dry fire hydrant had been damaged during the winter months - most likely from a snow plow. The head was completely missing and needed replacing. Upon further examination, it looked like the pipe was painted first and then the suction head glued onto the pipe during the initial installation. The problem created by that process was that the paint shielded the pipe from the glue and thus the head was not properly bonded onto the pipe. The repair required sanding off the old paint while being careful not to significantly reduce the diameter of the pipe since a tight, slip-fit connection was needed. Once the new head was installed, all exposed PVC pipe was painted with Krylon Fusion spray paint to protect from UV damage. The final step was a flow test - which produced a flow in excess of 1,000 gpm. |
|